Instruction Manual
Management Commands AT8904M
AT8904M CLI Reference Manual Page 6 - 30
6.9.2.1 no tacacs-server key
Use the no tacacs-server key command to disable the authentication and encryption
key for all TACACS+ communications between the switch and the TACACS+
daemon. The <key-string> parameter has a range of 0 - 128 characters This key must
match the key used on the TACACS+ daemon.
Format no tacacs-server key <key-string>
Mode Global Config
6.9.3 tacacs-server timeout
Use the tacacs-server timeout command to set the timeout value for
communication with the TACACS+ servers. The <timeout> parameter has a range of
1-30 and is the timeout value in seconds.
Default 5
Format tacacs-server timeout <timeout>
Mode Global Config
6.9.3.1 no tacacs-server timeout
Use the no tacacs-server timeout command to restore the default timeout value for
all TACACS servers.
Format no tacacs-server timeout
Mode Global Config
6.9.4 key
Use the key command in TACACS Configuration mode to specify the authentication
and encryption key for all TACACS communications between the device and the
TACACS server. This key must match the key used on the TACACS daemon. The
<key-string> parameter specifies the key name. For an empty string use “ ”. (Range: 0
- 128 characters).
Format key <key-string>
Mode TACACS Config
6.9.5 port
Use the port command in TACACS Configuration mode to specify a server port
number. The server <port-number> range is 0 - 65535.
Default 49
Format port <port-number>
Mode TACACS Config
6.9.6 priority
Use the priority command in TACACS Configuration mode to specify the order in
which servers are used, where 0 (zero) is the highest priority. The <priority>
parameter specifies the priority for servers. The highest priority is 0 (zero), and the
range is 0 - 65535.