Instruction Manual

Utility Commands AT8904M
AT8904M CLI Reference Manual Page 5 - 28
5.6.1 license advanced
This command enables a particular feature. This command also enables the
corresponding show commands for a feature.
NOTE: If the feature is enabled, the feature is visible in the output of the
show
running-config command. The <key> parameter specifies the hexa-
decimal key for the feature.
Default
none
Format license advanced <key>
Mode Privileged EXEC
5.6.1.1 no license advanced
This command disables a particular feature. This command also disables the
corresponding show commands. The
<key> parameter specifies the hexadecimal key
for the feature.
Format
no license advanced <key>
Mode Privileged EXEC
5.6.2 show key-features
This command displays the enabled or disabled status for all keyable features.
Format
show key-features
Modes Privileged EXEC
User EXEC
Function This is the name of the keyable component or feature.
Status Enabled or disabled.
5.7 Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system
time and date by using SNTP.
5.7.1 sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power
of two where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
5.7.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default
value.
Format
no sntp broadcast client poll-interval