Instruction Manual

AT8904M Routing Commands
Page 3 - 47 AT8904M CLI Reference Manual
Metric Val The metric value is applied based on the TOS. It defaults to the least
metric of the type of service among the interfaces to other areas. The
OSPF cost for a route is a function of the metric value.
Import Summary LSA Controls the import of summary LSAs into stub areas.
3.7.53 show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and
neighbor. The <
areaid> parameter identifies the area and the <neighbor> parameter
identifies the neighbor's Router ID.
Format
show ip ospf virtual-link <areaid> <neighbor>
Modes Privileged EXEC
User EXEC
Area ID The area id of the requested OSPF area.
Neighbor Router ID The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPF virtual interface.
Retransmit Interval The configured retransmit interval for the OSPF virtual inter-
face.
Authentication Type The configured authentication type of the OSPF virtual inter-
face.
State The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router. This is the state
of the OSPF interface.
Neighbor State The neighbor state.
3.7.54 show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the
system.
Format
show ip ospf virtual-link brief
Modes Privileged EXEC
User EXEC
Area Id The area id of the requested OSPF area.
Neighbor The neighbor interface of the OSPF virtual interface.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Retransmit Interval The configured retransmit interval for the OSPF virtual inter-
face.
Transit Delay The configured transit delay for the OSPF virtual interface.