Instruction Manual
AT8904M Routing Commands
Page 3 - 33 AT8904M CLI Reference Manual
3.7.26.1 no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
no external-lsdb-limit
Mode Router OSPF Config
3.7.27 ip ospf areaid
This command sets the OSPF area to which the specified router interface belongs. The
<areaid> is an IP address, formatted as a 4-digit dotted-decimal number or a decimal
value in the range of <0-4294967295>. The
<areaid> uniquely identifies the area to
which the interface connects. Assigning an area id, which does not exist on an
interface, causes the area to be created with default values.
Format
ip ospf areaid <areaid>
Mode Interface Config
3.7.28 ip ospf authentication
This command sets the OSPF Authentication Type and Key for the specified interface.
The value of <
type> is either none, simple or encrypt. The <key> is composed of
standard displayable, non-control keystrokes from a Standard 101/102-key keyboard.
The authentication key must be 8 bytes or less if the authentication type is simple. If
the type is encrypt, the key may be up to 16 bytes. If the type is encrypt a <
keyid> in
the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an
authentication key or authentication key ID. There is no default value for this
command.
Format
ip ospf authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode Interface Config
3.7.28.1 no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
Format
no ip ospf authentication
Mode Interface Config
3.7.29 ip ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a
range of 1 to 65535.
Default 10
Format
ip ospf cost <1-65535>
Mode Interface Config
3.7.29.1 no ip ospf cost
This command configures the default cost on an OSPF interface.
Format
no ip ospf cost