User Manual

AT8902M Management Commands
Page 6 - 19 AT8902M CLI Reference Manual
6.6.9.1 no snmp-server enable traps
This command disables the Authentication Flag.
Format no snmp-server enable traps
Mode Global Config
6.6.10 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Default enabled
Format snmp-server enable traps bcaststorm
Mode Global Config
6.6.10.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Format no snmp-server enable traps bcaststorm
Mode Global Config
6.6.11 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
“snmp trap link-status” on page 6 - 21.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
6.6.11.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format no snmp-server enable traps linkmode
Mode Global Config
6.6.12 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and
there is an existing terminal interface session.
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config