User Manual

AT8902M Utility Commands
Page 5 - 37 AT8902M CLI Reference Manual
Default inbound interface helper addresses
Format next-server <address>
Mode DHCP Pool Config
5.8.14.1 no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
5.8.15 option
The option command configures DHCP Server options. The <code> parameter
specifies the DHCP option code and ranges from 1-254. The
<ascii string>
parameter specifies an NVT ASCII character string. ASCII character strings that
contain white space must be delimited by quotation marks. The
hex <string>
parameter specifies hexadecimal data. In hexadecimal, character strings are two
hexadecimal digits. You can separate each byte by a period (for example, a3.4f.22.0c),
colon (for example, a3:4f:22:0c), or white space (for example, a3 4f 22 0c).
Default
none
Format option <code> {ascii string | hex <string1>
[<string2>...<string8>] | ip <address1>
[<address2>...<address8>]}
Mode DHCP Pool Config
5.8.15.1 no option
This command removes the DHCP Server options. The <code> parameter specifies the
DHCP option code.
Format
no option <code>
Mode DHCP Pool Config
5.8.16 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to
DHCP clients. Low-address and high-address are valid IP addresses; each made up of
four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
none
Format ip dhcp excluded-address <lowaddress> [highaddress]
Mode Global Config
5.8.16.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from
0 to 255. IP address 0.0.0.0 is invalid.
Format
no ip dhcp excluded-address <lowaddress> [highaddress]