User Manual

AT8902M Routing Commands
Page 3 - 37 AT8902M CLI Reference Manual
3.7.38.1 no maximum-paths
This command resets the number of paths that OSPF can report for a given destination
back to its default value.
Format
no maximum-paths
Mode Router OSPF Config
3.7.39 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for
both parameters is 0-65535 seconds.
Default delay-time—5
hold-time—10
Format
timers spf <delay-time> <hold-time>
Mode Router OSPF Config
3.7.40 trapflags (OSPF)
This command enables OSPF traps.
Default enabled
Format
trapflags
Mode Router OSPF Config
3.7.40.1 no trapflags
This command disables OSPF traps.
Format
no trapflags
Mode Router OSPF Config
3.7.41 show ip ospf
This command displays information relevant to the OSPF router.
Format
show ip ospf
Mode Privileged EXEC
NOTE: Some of the information below displays only if you enable OSPF and
configure certain features.
Router ID A 32-bit integer in dotted decimal format identifying the router, about
which information is displayed. This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router
is enabled or disabled. This is a configured value.
ASBR Mode Indicates whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router. Router
automatically becomes an ASBR when it is configured to redistribute
routes learnt from other protocol. The possible values for the ASBR
status is enabled (if the router is configured to re-distribute routes