Manual

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 6
6.2.3.1 no serial baudrate
This command sets the communication rate of the terminal interface.
Format
no serial baudrate
Mode Line Config
6.2.4 serial timeout
This command specifies the maximum connect time (in minutes) without console
activity. A value of 0 indicates that a console can be connected indefinitely. The time
range is 0 to 160.
Default 5
Format
serial timeout <0-160>
Mode Line Config
6.2.4.1 no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
no serial timeout
Mode Line Config
6.2.5 show serial
This command displays serial communication settings for the switch.
Format
show serial
Modes Privileged EXEC
User EXEC
Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity
on a Serial port connection, after which the Switch will close the con-
nection. Any numeric value between 0 and 160 is allowed, the factory
default is 5. A value of 0 disables the timeout.
Baud Rate (bps) The default baud rate at which the serial port will try to connect.
The available values are 1200, 2400, 4800, 9600, 19200,
38400,57600, and 115200 baud. The factory default is 9600 baud.
Character Size (bits) The number of bits in a character. The number of bits is
always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware
Flow Control is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is
always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is
always None.