Manual

AT8901/2/3
Page 5 - 35 AT8901/2/3 CLI Reference Manual
Default ethernet
Format
hardware-address <hardwareaddress> <type>
Mode DHCP Pool Config
5.9.6.1 no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
5.9.7 host
This command specifies the IP address and network mask for a manual binding to a
DHCP client. Address and Mask are valid IP addresses; each made up of four decimal
bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an
integer from 0 to 32
Default none
Format
host <address> [{<mask> | <prefix-length>}]
Mode DHCP Pool Config
5.9.7.1 no host
This command removes the IP address of the DHCP client.
Format
no host
Mode DHCP Pool Config
5.9.8 lease
This command configures the duration of the lease for an IP address that is assigned
from a DHCP server to a DHCP client. The overall lease time should be between 1-
86400 minutes. If you specify
infinite, the lease is set for 60 days. You can also
specify a lease duration.
Days is an integer from 0 to 59. Hours is an integer from 0 to
1439.
Minutes is an integer from 0 to 86399.
Default 1 (day)
Format
lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode DHCP Pool Config
5.9.8.1 no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode DHCP Pool Config
5.9.9 network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool
on the server. Network-number is a valid IP address, made up of four decimal bytes