Manual

AT8901/2/3
Page 5 - 25 AT8901/2/3 CLI Reference Manual
5.6.5 clear pass
This command resets all user passwords to the factory defaults without powering off
the switch. You are prompted to confirm that the password reset should proceed.
Format
clear pass
Mode Privileged EXEC
5.6.6 clear port-channel
This command clears all port-channels (LAGs).
Format
clear port-channel
Mode Privileged EXEC
5.6.7 clear traplog
This command clears the trap log.
Format
clear traplog
Mode Privileged EXEC
5.6.8 clear vlan
This command resets VLAN configuration parameters to the factory defaults.
Format
clear vlan
Mode Privileged EXEC
5.6.9 clear board event-log
This command deletes all event-log records
Format
clear board event-log
Mode Privileged EXEC
5.6.10 enable passwd
This command prompts you to change the Privileged EXEC password. Passwords are a
maximum of eight alphanumeric characters. The password is case sensitive.
Format
enable passwd
Mode User EXEC
5.6.11 logout
This command closes the current telnet connection or resets the current serial
connection.
NOTE: Save configuration changes before logging out.
Format
logout
Modes Privileged EXEC
User EXEC