Manual

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 16
3.3.6 ip irdp preference
This command configures the preferability of the address as a default router address,
relative to other router addresses on the same subnet.
Default 0
Format
ip irdp preference <-2147483648 to 2147483647>
Mode Interface Config
3.3.6.1 no ip irdp preference
This command configures the default preferability of the address as a default router
address, relative to other router addresses on the same subnet.
Format
no ip irdp preference
Mode Interface Config
3.3.7 show ip irdp
This command displays the router discovery information for all interfaces, or a
specified interface.
Format
show ip irdp {<slot/port> | all}
Modes Privileged EXEC
User EXEC
Interface Shows the <slot/port
> that matches the rest of the information in the
row.
Ad Mode Displays the advertise mode, which indicates whether router discovery
is enabled or disabled on this interface.
Advertise Address Displays the IP address to which the interface sends the advertise-
ment.
Max Int Displays the maximum advertise interval, which is the maximum time,
in seconds, allowed between sending router advertisements from the
interface.
Min Int Displays the minimum advertise interval, which is the minimum time,
in seconds, allowed between sending router advertisements from the
interface.
Hold Time Displays the amount of time, in seconds, that a system should keep the
router advertisement before discarding it.
Preference Displays the preference of the address as a default router address, rela-
tive to other router addresses on the same subnet.
3.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing
and to view VLAN routing status information.