Manual

AT8901/2/3
Page 3 - 9 AT8901/2/3 CLI Reference Manual
Format no ip route default [{<nexthopip> | <preference>}]
Mode Global Config
3.2.6 ip route distance
This command sets the default distance (preference) for static routes. Lower route
distance values are preferred when determining the best route. The
ip route and ip
route default
commands allow you to optionally set the distance (preference) of an
individual static route. The default distance is used when no distance is specified in
these commands. Changing the default distance does not update the distance of
existing static routes, even if they were assigned the original default distance. The new
default distance will only be applied to static routes created after invoking the
ip
route distance command.
Default 1
Format
ip route distance <1-255>
Mode Global Config
3.2.6.1 no ip route distance
This command sets the default static route preference value in the router. Lower route
preference values are preferred when determining the best route.
Format
no ip route distance
Mode Global Config
3.2.7 ip forwarding
This command enables forwarding of IP frames.
Default enabled
Format
ip forwarding
Mode Global Config
3.2.7.1 no ip forwarding
This command disables forwarding of IP frames.
Format
no ip forwarding
Mode Global Config
3.2.8 ip netdirbcast
This command enables the forwarding of network-directed broadcasts. When enabled,
network directed broadcasts are forwarded. When disabled they are dropped.
Default disabled
Format
ip netdirbcast
Mode Interface Config