User guide

AT8901M Management Commands
Page 6 - 13 AT8901M CLI Reference Manual
Mode
Global Config
6.5.1.1 no users name
This command removes a user account.
Format no users name <username>
Mode Global Config
NOTE: You cannot delete the “admin” user account.
6.5.2 users passwd
Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
password is case sensitive. When you change a password, a prompt asks for the old
password. If there is no password, press enter. You must enter the <username> in the
same case you used when you added the user. To see the case of the <username>, enter
the
show users command.
NOTE: To specify a blank password in the configuration script, you must
specify it as a space within quotes, for example, “ ”. For more informa-
tion about creating configuration scripts, see 6.10 “Configuration
Scripting Commands” on page 6 - 30.
Default no password
Format users passwd <username>
Mode Global Config
6.5.2.1 no users passwd
This command sets the password of an existing user to blank. When you change a
password, a prompt asks for the old password. If there is no password, press enter.
Format no users passwd <username>
Mode Global Config
6.5.3 users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The
valid accessmode values are
readonly or readwrite. The <username> is the login
user name for which the specified access mode applies. The default is
readwrite for
the “admin” user and
readonly for all other users. You must enter the <username> in
the same case you used when you added the user. To see the case of the <username>,
enter the
show users command.
Default admin - readwrite
other - readonly
Format users snmpv3 accessmode <username> {readonly | readwrite}
Mode Global Config