User guide

Utility Commands AT8901M
AT8901M CLI Reference Manual Page 5 - 4
5.1.8 startupslot activate
This command sets the startup slot to active and will use this in all subsequent reboots.
Using [once] at the end of the command will set the startup slot to be used once during
the next restart. The start sequence will reset the startup slot to the previously installed
one. This enables a try-once with automatic rollback in case of error.
Format
startupslot <slotnumber> activate [once]
Mode Global Config
5.1.9 show startupconfig
This command shows either the installed system images or configuration files. For
“startup” it shows the information about images and configuration files used at system
startup. For “all” it shows all the information about installed images/files and the
startup information.
Format
show startupconfig {initrd | startup | config | all}
Mode Privileged EXEC
5.2 ATCA commands
5.2.1 set board sensor threshold
This command sets a new threashold value for a sensor. The <record-id> (of SDR) for
a specific sensor is displayed by the related “show” command
Format
set board sensor threshold <record-id> <value-type>
<value>
Mode Privileged EXEC
<Value-type>
• lower-non-critical Set lower non-critical threshold value
• lower-critical Set lower critical threshold value
• lower-non-recover Set lower non-recoverable threshold value
• upper-non-critical Set upper non-critical threshold value
• upper-critical Set upper critical threshold value
• upper-non-recover Set upper non-recoverable threshold value
5.2.2 set board ipmi-controller debug
This command enables temporary IPMI controller serial debug output on the
management serial console. .
Format
set board ipmi-controller debug {on | off}
Mode Privileged EXEC
NOTE: Use this command with care as it may render the console useless until a full
board reset is executed