User guide

AT8901M Quality of Service (QoS) Commands
Page 4 - 15 AT8901M CLI Reference Manual
4.4.2 drop
This command specifies that all packets for the associated traffic stream are to be
dropped at ingress.
Format
drop
Mode Policy-Class-Map Config
Incompatibilities Assign Queue, Mark (all forms), Mirror, Police, Redirect
4.4.3 mirror
This command specifies that all incoming packets for the associated traffic stream are
copied to a specific egress interface (physical port or LAG).
NOTE: This command is not available on the Broadcom 5630x platform.
Format
mirror <slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Redirect
4.4.4 redirect
This command specifies that all incoming packets for the associated traffic stream are
redirected to a specific egress interface (physical port or port-channel).
NOTE: This command is not available on the Broadcom 5630x platform.
Format
redirect <slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Mirror
4.4.5 conform-color
Use this command to enable color-aware traffic policing and define the conform-color
class map. Used in conjunction with the police command where the fields for the
conform level are specified. The <class-map-name> parameter is the name of an
existing Diffserv class map.
NOTE: This command may only be used after specifying a police command
for the policy-class instance.
Format
conform-color <class-map-name>
Mode Policy-Class-Map Config
4.4.6 class
This command creates an instance of a class definition within the specified policy for
the purpose of defining treatment of the traffic class through subsequent policy
attribute statements. The
<classname> is the name of an existing DiffServ class.
NOTE: This command causes the specified policy to create a reference to the
class definition.