Owner's manual

Introduction
8 AT8404 User Guide
www.kontron.com
General
Humidity
Designed to meet or exceed the following:
• Bellcore GR-63, Section 4.1
• Operating: 15%-90% (non-condensing) at 55°C (131°F)
• Non-Operating: 5%-95% (non-condensing) at 40°C (104°F)
Altitude
Designed to meet or exceed the following:
• Operating: 4000 m (13123 ft)
• Non-operating: 15000 m (49212 ft)
Vibration
Designed to meet or exceed the following:
• Bellcore GR-63, Section 4.4
• ETSI EN 300 019-2-3
• Operating: Sinusoidal 1.0G (5-100Hz), 0.2G (100-200Hz), each axis
• Packaged: Random 0.89Grms (5-200Hz), each axis
Shock
Designed to meet or exceed the following:
• DIN/IEC 60068-2-27
• Bellcore GR-63, Section 4.3
• ETSI EN 300 019-2-3
• Operating: 3G, half-sine 11ms, each axis
• Packaged: 18G, half-sine 6ms, each axis
Safety
Designed to meet or exceed the following:
• CB report to IEC 60950-1, complies with EN/CSA/ UL 60950-1
EMC
Designed to meet or exceed the following:
• FCC 47 CFR Part 15, Subpart B
• EN55022, EN55024
• EN 300 386
Reliability • MTBF: > 384,000 hours @ 40°C/104°F (Telcordia SR-332, Issue 1)
HW Monitoring
LEDs
ATCA LEDs:
• 4 LEDs ("Ready for Hot Swap", "Out of Service", "Healthy", "Activity")
Board Management
• based on IPMI 1.5
• FRU Management
• Sensors (Voltage, Current, Temperature, Fuse)
• Status and Alerting
• Hot Swap Management for Base Board and AMC
• Electronic Keying of Base and Fabric Interfaces and AMC ports
• Local SEL
Table 1-2: AT8404 Main Specifications
AT8404 SPECIFICATIONS