Instruction Manual

FASTPATH log messages AT8404
AT8404 CLI Reference Manual Page B - 14
B.7 O/S Support
Broadcom USL: A Trunk being destroyed doesn't exist in
USL
Possible synchronization issue between the
application, hardware, and sync layer.
Broadcom USL: A Trunk being set doesn't exist in USL Possible synchronization issue between the
application, hardware, and sync layer.
Broadcom USL: failed to sync trunk table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: Mcast entry not found on a join Possible synchronization issue between the
application, hardware, and sync layer
Broadcom USL: Mcast entry not found on a leave Possible synchronization issue between the
application, hardware, and sync layer
Broadcom USL: failed to sync dvlan data on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync policy table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync VLAN table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom Invalid LAG id x Possible synchronization issue between the
BCM driver and HAPI
Broadcom Invalid uport calculated from the BCM uport
bcmx_l2_addr->lport = x
Uport not valid from BCM driver.
Broadcom Invalid USP calculated from the BCM
uport\nbcmx_l2_addr->lport = x
USP not able to be calculated from the learn
event for BCM driver.
Broadcom Unable to insert route R/P Route ‘R’ with prefix ‘P’ could not be inserted
in the hardware route table. A retry will be
issued.
Broadcom Unable to Insert host H Host ‘H’ could not be inserted in hardware
host table. A retry will be issued.
Broadcom USL: failed to sync L3 Intf table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync L3 Host table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync L3 Route table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync initiator table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync terminator table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Broadcom USL: failed to sync ip-multicast table on unit=x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued
Table 35: Broadcom Error Messages (Continued)
Component Message Cause