Instruction Manual

AT8404 Management Commands

Page 5 - 47 AT8404 CLI Reference Manual

5.12 Pre-login Banner and System Prompt Commands

This section describes the commands you use to configure the pre-login banner and the system prompt. The pre-

5.12.1 copy (pre-login banner)

The copy command includes the option to upload or download the CLI Banner to or from the switch. You can specify

local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.

5.12.2 set prompt

This command changes the name of the prompt. The length of name may be up to 64 alphanumeric characters.

5.13 Diagnostics Commands

5.13.1 diagnostics

This command will start diagnostics. If “interactive” is specified the switch will be restarted and the diagnostics

loaded. The user gets a menu to select interactively a scenario. A serial console is needed. Otherwise, if a scenario

is specified, this scenario is executed directly. You may start this scenario once or repeated for a time (timedloop),

for a number of repetitions (loop) or forever. The results are stored and can be displayed by using “show logging

diag-report”. Possible scenarios are “full” (all test purposes except the destructive ones), “quickturn” (scenarios

running fast) or “write” (destructive scenarios).

5.13.2 show logging diag-report

This command displays the results of the last diagnostic run. The diagnostic results file is created by a diagnostic

run..

5.14 PCI express Commands

5.14.1 show boardinfo pcie

This command displays the PCI Express clock settings.

Default none

Format copy

<tftp://<ipaddr>/<filepath>/<filename>> nvram:clibanner

copy nvram:clibanner

<tftp://<ipaddr>/<filepath>/<filename>>

Mode Privileged EXEC

Format set prompt <prompt_string>

Mode Privileged EXEC

Format diagnostics interactive

diagnostics <scenario> {{timedloop | loop} <1-9999999> | forever}

Mode Priviledged EXEC

Format show logging diag-report

Mode Priviledged EXEC