User Manual

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 62
Format set igmp fast-leave
Mode Interface Config
Format
set igmp fast-leave <vlan_id>
Mode VLAN Config
2.15.3.1 no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected
interface.
Format
no set igmp fast-leave
Modes Interface Config
Format
no set igmp fast-leave <vlan_id>
Mode VLAN Config
2.15.4 set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one
interface or all interfaces. The Group Membership Interval time is the amount of time
in seconds that a switch waits for a report from a particular group on a particular
interface before deleting the interface from the entry. This value must be greater than
the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds.
Default 260 seconds
Format
set igmp groupmembership-interval <2-3600>
Modes Interface Config
Global Config
Format
set igmp groupmembership-interval <vlan_id> <2-3600>
Modes VLAN Config
2.15.4.1 no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
no set igmp groupmembership-interval
Modes Interface Config
Global Config
Format
no set igmp groupmembership-interval <vlan_id>
Mode VLAN Config
2.15.5 set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a
particular interface or VLAN. The Maximum Response time is the amount of time in
seconds that a switch will wait after sending a query on an interface because it did not
receive a report for a particular group in that interface. This value must be less than the
IGMP Query Interval time value. The range is 1 to 3599 seconds.