User Manual

AT8402 Switching Commands
Page 2 - 53 AT8402 CLI Reference Manual
NOTE: Before adding a port to a port-channel, set the physical mode of the
port. For more information, see 2.1.8 “speed” on page 2 - 4.
Format
addport <logical slot/port>
Mode Interface Config
2.12.3 deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a logical
slot/port number. of a configured port-channel.
Format
deleteport <logical slot/port>
Mode Interface Config
2.12.4 deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface
is a logical slot/port number. of a configured port-channel. To clear the port channels,
see 4.5.6 “clear port-channel” on page 4 - 25
Format
deleteport {<logical slot/port> | all}
Mode Global Config
2.12.5 port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default
the static mode for a new port-channel is disabled, which means the port-channel is
dynamic. However if the maximum number of allowable dynamic port-channels are
already present in the system, the static mode for a new port-channel enabled, which
means the port-channel is static.You can only use this command on port-channel
interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
2.12.5.1 no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the
default value. This command will be executed only for interfaces of type port-channel
(LAG).
Format
no port-channel static
Mode Interface Config
2.12.6 port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default enabled
Format port lacpmode
Mode Interface Config