User Manual

AT8402 Switching Commands
Page 2 - 5 AT8402 CLI Reference Manual
2.1.9 speed all
This command sets the speed and duplex setting for all interfaces.
Format
speed all {<100 | 10> <half-duplex | full-duplex>}
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
2.1.10 block
This command sets a port in blocking mode. A blocking port will not receive or
forward data frames. The command is only allowed if no spanning tree is enabled
because the spanning tree is setting the port states itself. If the port is currently
disabled, the state is not changed until it will become enabled. The state of the ports
can be listed (spanning tree) by using:
show spanning-tree mst port summary 0 all
Format block
Mode Interface Config
2.1.10.1 no block
This command resets a port in non-blocking mode.
Format
no block
Mode Interface Config
2.1.11 show port
This command displays port information.
Format
show port {<slot/port> | all}
Mode Privileged EXEC
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mirror - this port is a monitoring port. For more information, see 2.13
“Port Mirroring” on page 2 - 56.
PC Mbr- this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode The Port control administration state. The port must be enabled in
order for it to be allowed into the network. - May be enabled or dis-
abled. The factory default is enabled.