User Manual

AT8402 Management Commands
Page 5 - 37 AT8402 CLI Reference Manual
set board storage connect amcb3 sas
set board storage connect amcb4 amcb2
set board storage connect amcb4 sas
Mode Privileged EXEC
5.15.2 show boardinfo storage
This commands displays information about a connection from an AMC to a storage
modul.
Format
show boardinfo storage
show boardinfo storage amcb1
show boardinfo storage amcb3
Mode Privileged EXEC
5.15.3 set board sasexp program
This command sets the front plate serial interface to the SAS Expander to program the
SAS Expander EEPROM.
Format
set board sasexp program enable
set board sasexp program disable
Mode Privileged Exec
5.15.4 show board sasexp program
This command displays the mode of the SAS expander programming.
Format
show board sasexp program
Mode Privileged Exec
5.16 Clock Support Commands
5.16.1 show boardinfo pll status
This command shows the PLL status.
Format
show boardinfo pll status
Mode Privileged Exec
5.16.2 show boardinfo pll config
This command shows the PLL configuration. The PLL configuration parameters are
described below for the “set” command.
Format
show boardinfo pll config
Mode Privileged Exec
5.16.3 set board pll
This command shows the PLL configuration. Parameters are
• switching (manual switching/holdover switching/loss of clock)
• mode (normal operation/holdover/free run)