User Manual

AT8402 Management Commands
Page 5 - 21 AT8402 CLI Reference Manual
Format snmptrap mode <name> <ipaddr>
Mode Global Config
5.6.17.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive
traps.
Format
no snmptrap mode <name> <ipaddr>
Mode Global Config
5.6.18 snmp trap link-status
This command enables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See “snmp-server enable traps linkmode” on page 5 - 19.
Format
snmp trap link-status
Mode Interface Config
5.6.18.1 no snmp trap link-status
This command disables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
Format
no snmp trap link-status
Mode Interface Config
5.6.19 snmp trap link-status all
This command enables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See “snmp-server enable traps linkmode” on page 5 - 19.
Format
snmp trap link-status all
Mode Global Config
5.6.19.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See “snmp-server enable traps linkmode” on page 5 - 19.
Format
no snmp trap link-status all
Mode Global Config
5.6.20 show snmpcommunity
This command displays SNMP community information. Six communities are
supported. You can add, change, or delete communities. The switch does not have to be
reset for changes to take effect.