User Manual

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 14
Default admin - readwrite
other - readonly
Format
users snmpv3 accessmode <username> {readonly | readwrite}
Mode Global Config
5.5.3.1 no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite
for the “admin” user and readonly for all other users. The <username> value is the
user name for which the specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode Global Config
5.5.4 users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid
authentication protocols are none, md5 or sha.
If you specify md5 or sha, the login password
is also used as the snmpv3 authentication password and therefore must be at least eight
characters in length. The <username>
is the user name associated with the
authentication protocol. You must enter the <username> in the same case you used
when you added the user. To see the case of the <username>, enter the
show users
command.
Default no authentication
Format
users snmpv3 authentication <username> {none | md5 | sha}
Mode Global Config
5.5.4.1 no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to
none. The <username> is the user name for which the specified authentication
protocol is used.
Format
no users snmpv3 authentication <username>
Mode Global Config
5.5.5 users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
des or none.
If you select
des, you can specify the required key on the command line. The
encryption key
must be 8 to 64 characters long. If you select the des protocol but do
not provide a key, the user is prompted for the key. When you use the
des protocol, the
login password is also used as the snmpv3 encryption password, so it must be a
minimum of eight characters. If you select
none, you do not need to provide a key.
The <username> value is the login user name associated with the specified encryption.
You must enter the <username> in the same case you used when you added the user.
To see the case of the <username>, enter the
show users command.
Default no encryption