Manual

31 AT8242
www.kontron.com
Table 4-2:Privilege Level Description
The User ID 1 is a user without name and password. This user can be enabled or disabled and has a privilege
level set to “User” by default.
The User ID2 is pre-configured like an admin user. It has the “Administrator” privileges.
The User ID3 to User ID5 are configurable. By default they are set to “Disable”.
4.2.5.5 Logout
This button allows a safe logout of the management interface. An automatic logout will be done after 5
minutes of inactivity.
4.3 IPMC
4.3.1 Supported commands
The tables below list the IPMI commands supported by the IPMC. These tables are identical as the ones
provided by PICMG 3.0. The last column states the Kontron support for the specific command.
Table 4-3:IPM Device Supported Commands for IPMC
Privilege Level Description
Administrator
All BMC commands are allowed, including configuration settings. An Administrator
can even execute configuration commands that would disable the channel that the
Administrator is working on.
Operator
All BMC commands are allowed, except for configuration settings which can
change the behavior of the out-of-band interfaces. For example, Operator
privilege does not allow the capability to disable individual channels, or change
user access privileges.
User
Only “basic” commands are allowed. These are primarily commands that read data
and retrieve status. Commands that can be used to alter BMC configuration, write
data to the management controllers, or perform system actions such as resets,
power on/off, and watchdog activation are locked.
Callback
This may be considered the lowest privilege level. Only commands necessary to
support initiating a callback are allowed.
No Access No access is given to this user.
 IPMI Spec. section NetFn CMD IPMI BMC req. Carrier IPMC req. Kontron support
on IPMC
IPM Device "Global"
Commands
   M M 
Get Device ID 20.1 App 01h M M Yes
Cold Reset 20.2 App 02h O O Yes
Warm Reset 20.3 App 03h O O No
Get Self Test Results 20.4 App 04h M M Yes