Manual

22 AT8242
www.kontron.com
3.4 Onboard Connectors and Headers
Table 3-2:Onboard Connectors and Headers
3.5 Board Hot Swap and Installation
Because of the high-density pinout of the hard-metric connector, some precautions must be taken when
connecting or disconnecting a board to/from a backplane:
1 Rail guides must be installed on the enclosure to slide the board to the backplane.
2 Do not force the board if there is mechanical resistance while inserting the board.
3 Screw the front plate to the enclosure to firmly attach the board to its enclosure.
4 Use ejector handles to disconnect and extract the board from its enclosure.
Description Connector Comments
Memory Socket NPU0 Channel 1 J1 DDR3 UDIMM Memory Socket
Memory Socket NPU0 Channel 3 J2 DDR3 UDIMM Memory Socket
Memory Socket NPU0 Channel 2 J3 DDR3 UDIMM Memory Socket
Memory Socket NPU0 Channel 0 J4 DDR3 UDIMM Memory Socket
Memory Socket NPU1 Channel 1 J5 DDR3 UDIMM Memory Socket
Memory Socket NPU1 Channel 3 J6 DDR3 UDIMM Memory Socket
Memory Socket NPU1 Channel 2 J7 DDR3 UDIMM Memory Socket
Memory Socket NPU1 Channel 0 J8 DDR3 UDIMM Memory Socket
Debug Connector J9
eUSB Flash Connector NPU0 J10
eUSB Flash Connector NPU1 J11
Management/Console Port J13
UC Memory connector J15 DDR3 SO-UDIMM Memory Socket
RTM Connectors J31 & J32
Base & Fabric Interface Connector J20 & J23
Power Connector P10
Reset Switch SW1
User Switch SW2
Handle Switch SW3
WARNING
Always use a grounding wrist strap before installing or removing the board from a
chassis.