User Manual

Software Setup
108 AT8060
www.kontron.com
5.3 Console Redirection (VT100 Mode)
The VT100 operating mode allows remote setup of the board. This configuration requires a remote terminal
that must be connected to the board through a serial communication link.
5.3.1 Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal emulation programs such as Putty,
Telix©, HyperTherminal(Windows), minicom(Linux) or ProComm©(Windows) can also be used.
5.3.2 ANSI and VT100 Keystroke Mapping
5.3.3 VT-UTF8 Keystroke Mapping
The following "escape sequences" are defined in the "Conventions for Keys Not in VT100 Terminal Definition
and ASCII Character Set" section of "Standardizing Out-of-Band Management Console Output and Terminal
Emulation (VT-UTF8 and VT100+)",available for download at microsoft.com.
Up <ESC>[A
Down <ESC>[B
Right <ESC>[C
Left <ESC>[D
Home <ESC>[H
End <ESC>[K
F1 <ESC>OP
F2 <ESC>OQ
F3 <ESC>OR
F4 <ESC>OT
F1 Key <ESC>1
F2 Key <ESC>2
F3 Key <ESC>3
F4 Key <ESC>4
F5 Key <ESC>5
F6 Key <ESC>6
F7 Key <ESC>7
F8 Key <ESC>8
F9 Key <ESC>9
F10 Key <ESC>0