Manual

30 AT8050
www.kontron.com
3. Installing the Board
3.1 Setting Jumpers
3.1.1 Jumper Description
Table 3-1: Jumper Description
3.1.2 Setting Jumper & Locations
Figure 3-1: Jumper Settings and Locations
Name Description Jumper
FW Write Protect When On, it enables the firmware write protect JP1 (1-2)
FPGA PROM Selection When On, it selects the factory prom JP1 (3-4)
Clear CMOS Setup When On, it clears the CMOS Setup JP1 (5-6)
Reserved Reserved JP1 (7-8)
Reserved Reserved JP1 (9-10)
Reserved Reserved JP1 (11-12)
Reserved Reserved JP1 (13-14)
Watchdogs When On, it disables the watchdogs JP2 (1-2)
Shelf Manager Activation When On, it overrides the Shelf Manager activation JP2 (3-4)
IPMI When On, it resets the IPMC JP2 (5-6)
AMC & RTM Activation When On, it overrides the AMC & RTM activation JP2 (7-8)
Reserved Reserved JP2 (9-10)
Reserved Reserved JP2 (11-12)
Reserved Reserved JP2 (13-14)
Note:
More details about the jumper settings can be found on the Quick Reference Sheet.
J8
J9
JP1
JP2
1 3 5 7 9 11 13
2 4 6 8 10 12 14
1 3 5 7 9 11 13
2 4 6 8 10 12 14
J5
1
4
J2
Fill Fill Fill
JUMPER SETTINGS ( Default Setting)
JUMPER SETTINGS ( Default Setting)
JP2 (1-2) Watchdogs
in
out
Disabled
Enabled
JP2 (3-4) Shelf Manager Activation
in
out
Override
Normal Operation
JP2 (7-8) AMC & RTM Activation
in
out
Override
Normal Operation
in
out
Reserved
Reserved
JP2 (9-10) Reserved
in
out
Reserved
Reserved
in
out
Reserved
Reserved
in
out
Override
Normal
JP2 (5-6) IPMI
JP1 (1-2) FW Write Protect
in
out
Protected
Non Protected
JP1 (3-4) FPGA PROM Selection
in
out
Factory Prom
Normal
JP1 (5-6) Clear CMOS Setup
in
out
Clear CMOS
Normal Operation
JP1 (7-8) Reserved
in
out
Reserved
Reserved
JP1 (9-10) Reserved
in
out
Reserved
Reserved
JP1 (11-12) Reserved
in
out
Reserved
Reserved
JP1 (13-14) Reserved
in
out
Reserved
Reserved
JP2 (11-12) Reserved
JP2 (13-14) Reserved