Manual

A-6 AT8050
www.kontron.com
A.4.1 Register Description
A.4.1.1 Base + 00h TelClock0: Backplane Clock Status, PLL Reference &
Interface Selection
Offset Action D7 D6 D6 D4 D3 D2 D1 D0
00h
Read IFSEL MAN SEL_REFA BP_REF CLK2B CLK2A CLK1B CLK1A
Write IFSEL* MAN SEL_REFM BP_REF NU NU NU NU
Reset 0 0 0 0 NA NA NA NA
Name Description
IFSEL
Interface selection. This bit is always writable from the IPMC side but on the LPC side, the CPU can only
read it.
1: IPMC has write control of the interface
0: Main CPU (LPC) has write control of the interface
MAN
0: The PLD chooses automatically the reference used by the DPLL (CLKA or B).
1: Selection of the DPLL reference is manual. Write the selection in bit SEL_REF.
SEL_REFA
SEL_REFM
On a read, return the reference automatically selected by the CPLD:
0: REF0 is the reference used by the PLL (i.e. CLKA)
1: REF1 is the reference used by the PLL (i.e. CLKB)
When bit MAN=1, the application software can select the reference by writing the desired value in this
bit. This bit is not writtable when MAN=0. Note that on a read, this bit returns the automatic selection
event if MAN=1.
BP_REF
Backplane selection of clock to connect to the PLL.
0: Use backplane CLK1A and CLK1B (8kHz)
1: Use backplane CLK2A and CLK2B (19.44MHz)
CLK1A/B
CLK2A/B
Coarse monitoring status. A1 indicate that the corresponding backplane clock is present. A0, that it is
absent. Those statuses are valid only if CLK1A/B is 8kHz and CLK2A/B is 19.44MHz. If other
frequencies are used, those bits should be ignored.