Certifications 2

Stop leak if you can do so without risk. Move the cylinder to a safe and open area if the leak is
irreparable. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate
area). Keep combustibles (wood, paper, oil etc) away from spilled material. The product is
immiscible with water and will spread on the water surface. Prevent product from entering drains.
Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery,
flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
6.3. Methods and material for
containment and cleaning up
For personal protection, see section 8 of the SDS. For waste disposal, see section 13 of the SDS.
6.4. Reference to other
sections
SECTION 7: Handling and storage
Pressurised container: Do not pierce or burn, even after use. Do not use if spray button is missing
or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke
while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. All equipment used when
handling the product must be grounded. Do not re-use empty containers. Avoid breathing
mist/vapours. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Use only in
well-ventilated areas. Wear appropriate personal protective equipment. Avoid release to the
environment. Observe good industrial hygiene practices.
7.1. Precautions for safe
handling
Pressurized container. Protect from sunlight and do not expose to temperatures exceeding 50°C.
Do not puncture, incinerate or crush. Do not handle or store near an open flame, heat or other
sources of ignition. This material can accumulate static charge which may cause spark and
become an ignition source. Store away from incompatible materials (see Section 10 of the SDS).
Storage class (TRGS 510): 2B (Aerosol dispensers and lighters)
7.2. Conditions for safe
storage, including any
incompatibilities
Not available.
7.3. Specific end use(s)
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
UK. EH40 Workplace Exposure Limits (WELs)
ValueComponents Type
STEL 560 mg/m31-METHOXY-2-PROPANOL
;
MONOPROPYLENE
GLYCOL METHYL ETHER
(CAS 107-98-2)
150 ppm
TWA 375 mg/m3
100 ppm
STEL 462 mg/m3Butan-2-ol (CAS 78-92-2)
150 ppm
TWA 308 mg/m3
100 ppm
STEL 899 mg/m3butanone; ethyl methyl
ketone (CAS 78-93-3)
300 ppm
TWA 600 mg/m3
200 ppm
STEL 27400 mg/m3Carbon dioxide (CAS
124-38-9)
15000 ppm
TWA 9150 mg/m3
5000 ppm
STEL 1250 mg/m3Propan-2-ol; Isopropyl
alcohol; Isopropanol (CAS
67-63-0)
500 ppm
TWA 999 mg/m3
400 ppm
SDS GREAT BRITAIN
Material name: KONTAKT WL - Kontakt chemie - Europe
BDS000542AE Version #: 1.0 Revision date: 24-March-2022 Issue date: 19-May-2021
4 / 12