User Manual

2.) Mounting the equipment and adjusting the desired position
!When adjusting the position, there is a crushing risk between the components!
Screw the equipment onto the stand. If necessary, the
equipment can be locked in place with the help of the
knurled disc.
To adjust the direction or the angular position, hold the
screwed-on equipment and loosen the clamping screw.
Set the desired position and retighten clamp.
Dismantling is carried out in reverse order.
Mounting
To mount the desktop camera stand, proceed as follows:
1.) Unpack and check product for damage and completeness
Technical data
Material
Base, legs, protective cap: plastic, black
Knurled washer: Black anodised
Threaded bolt, clamping bolt, ball joint: Steel, galvanised
Joint: Zinc die-cast, powder-coated black
Threaded pin: Steel, blank
Clamping screw: PA and steel, zinc plated
Rivet: Brass
Load capacity 1 kg
Dimensions and
adjustment range
Base circle ø 240 mm
Height 118 mm
Ball joint 360° rotable and 90° tiltable
Packaging 63 x 63 x 196 mm
Weight 0.2 kg
The desktop camera stand is completely assembled.
To set up the stand, unfold the three legs.