User Manual

Fault and troubleshooting

Fault/cause Check/Remedy

Unsteady and wobbly stand

● Check the floor for unevenness and adjust the set

● screws, if necessary.

Components of the accordion

stand wobble

● Check screw connections and tighten if necessary.

Instrument wobbles

● Check tension and rubber pads. The rubber pads must

● be in full contact with the instrument.

2.) Fitting the accordion.

Maintenance, cleaning and repair

u Maintenance: Regularly check if the screw connections are tight.

u Cleaning: Use a slightly damp cloth to clean the accordion stand. Do not use chlorinated

u or abrasive cleaning agents. These will cause damage to the surface and varnish.

u Repair: Immediately repair any damage that occurs and stop using the accordion stand.

u Maintenance work may only be carried out if you have the necessary knowledge. If any parts

u are missing, contact the manufacturer at www.k-m.de. Here you can find a corresponding

u spare parts list by entering the article number on the type label. Use this page to reorder

u missing or damaged components.

Before fitting the accordion, pre-adjust the distances of the

holder. The dimension can be adjusted by using the two

clamping screws 1.

Loosen the knurled screw 2 and swivel the upper support

arm to the side.

Hold the instrument securely and carefully place the accor-

dion into the holder. Swivel the support arm back to its

original position and finger-tighten the knurled screw 2.

Tighten the clamping screws 1 to hold the instrument in

the desired position. Make sure that the rubber pads lie

flat against the housing.

The tilt of the accordion can be adjusted with the knob 3.

To do this, loosen the knob, set the desired inclination and

retighten.