User Manual
USE INSTRUCTIONS/FUNCTIONS
TEST, MAINTENANCE, CLEANING DIMENSIONS
- When maintaining the throne, be aware of the potential for injury (pinching, knocking).
- It is best to use a slightly damp cloth and a non-abrasive cleaning agent for cleaning.
FAULT FINDING (F) and SOLUTION (S)
F: Height adjustment of the tube difficult:
S: Foreign bodies or dirt between the tubes: carefully clean the tubes; adjust the pre-setting
S: of the clamping lever 6, 7, 9
F: The pull-out tube wobbles or retracts under pressure:
S: Check the ratchet pin, adjust the pre-setting of the clamping lever 6, 7, 9
F: Base section and legs very stiff:
S: Apply a little silicon spray.
3. HEIGHT ADJUSTMENT
TECHNICAL DATA /SPECIFICATIONS
Materials
Steel tube and steel struts - chrome plated
Ring - PA-6 black
Clamping lever, ratchet knob - POM grey
Floor protectors – TPE Evoprene, black
Upholstered seat – artificial leather, black
Max. weight 100 kg
1. FUNCTION of the CLAMPING RING
1. a. SEAT HEIGHT: the pin 13 locks the pull-out tube in place
1. b. STABILITY: when closed, the clamping lever 14 locks the base tube and the pull-out tube and ensures there is no seat wobble
2. PRE-TIGHTENING THE CLAMPING RING
The clamping ring is pre-set at the factory.
AIM:
a. When the clamping lever is closed, the pull-out tube 8 should be immoveable due to the function of the clamping ring.
b. When the clamping lever 6 is open, the height of the pull-out tube can be adjusted.
- Open the grey clamping
- lever 10
- Open the clamping lever 6 - Tighten with Allen key 7
- Re-close clamping lever 9
- And repeat the procedure
- if necessary.
- Pull on the ratchet knob 11 and
- Pull out the pull-out tube 12 to
- the desired height
- Allow the ratchet knob 13 to slot
- into the corresponding slit
- Re-close the grey
- clamping lever 14
Measurements
Upholstered seat: ø 330 x 80 mm
Seat height: 485 - 685 mm
Footprint diameter: 620 mm
Own weight 4.7 kg (5.4 kg with cardboard box)
Packing
Single carton: L x B x H
520 x 330 x 180 mm
PROCEDURE:
For the clamp is to function correctly
the clamping lever 9 must be closed
very firmly.
If the clamping lever closes too
easily, then the following correction
should be made:
485 - 685 mm