User Manual

3.) Mounting the tabletop
Maintenance, cleaning and repair
u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the DJ desk. Do not use chlorinated or abrasive
u cleaning agents. These will cause damage to the surface and varnish.
u Repair: Immediately repair any damage that occurs and stop using the DJ desk. Maintenance
u work may only be carried out if you have the necessary knowledge. If any parts are missing,
u contact the manufacturer at www.k-m.de. Here you can find a corresponding spare parts list by
u entering the article number on the type label. Use this page to reorder missing or damaged
u components.
To assemble the tabletop, the support tubes must be scre-
wed onto the U-frame. For this, place the support tube on
the U-frame with the recess facing downwards. Insert the
carriage bolt from above through the support tube and the
U-frame. Screw the carriage bolt from below with the was-
her and the clamping nut. Tighten the clamping nut hand-
tight. Repeat the procedure with the second support tube
on the other side.
Stick two felt pads on the top of each support tube.
To place the tabletop, the four quick-release clamps must
be "opened", by pressing the red button on the quick-
release clamps. The locking pin snaps back and the table-
top can be mounted or dismounted. Place the tabletop on
the support tubes and secure it with the support tubes by
pressing the locking pins. Make sure that the locking pins
are inserted into the holes and bolted.
Please note: If the locked tabletop has too much space on
the U-frame, proceed as follows: Open the clamping screw
from the support tube, pull the support tube outwards and
close the clamping screw again. Same procedure on the
opposite side.