User Manual

Mounting
!Due to the adjustment option, there is a risk of crushing between the components!
1.) Unpack and check product for damage and completeness.
Technical data
Material
base frame, U-frame, support tube: Steel powder-coated, black
Carriage bolt, washer, bolt, screw: Steel, galvanised
End caps, housing, spacer plate, clamping nut: Plastic, black
Felt pad: Felt, black
Tabletop: MDF, black laminated
Load capacity 30 kg
Dimensions and
adjustment range
1100 x 455 x 605 mm
Height: 605 - 1055 mm in 30 mm increments
Packaging
Base frame: 970 x 630 x 75 mm
Tabletop: 1184 x 454 x 37 mm
Weight 13.5 kg
1 Accessory bag: Carriage
1 bolt, clamping nut, washer,
1 felt pads.
2 Accessory bag: Spring-
2 loaded clamping knob.
3 Tabletop with quick-
3 release clamps, support
3 tubes.
4 U-frame, base frame.
2
4
1
3
2.) Assembly of base frame
Screw spring-loaded clamping knobs into
the U-frame with approx. five turns. Slide
the base frame into the U-frame. Make
sure that the holes in the base frame point
in the direction of the locking screw. Tighte-
ning the spring-loaded clamping knobs to
fix the height of the base frame.
PLEASE NOTE: In order to be able to slide
the base frame into the U-frame, the spring-
loaded clamping knob must be drawn back-
wards. By pulling the handle, the fastening
bolt releases the tube. Set the desired
height, release the spring-loaded clamping
knob and make sure that the fastening bolt
engages in a hole. Tighten the spring-
loaded clamping knob hand-tight. If the
base frame cannot be pushed into the
U-frame despite pulling the spring-loaded
clamping knob, then the clamping handle
should be slightly unscrewed.