IR-EGGS2 REMOTE CONTROL EXTENDER
LOCATION OF CONTROLS Receiver Side Transmitter Side IR Probe DC Power DC Power Transmitter and Receiver Front Infrared Remote Control Antenna Remote Control Indicators & IR Transmitter/Receiver Accessory DC 12 V AC 220V or 240V Adaptor x2 Infrared Extender X 1
CAUTION: This equipment has been tested and found to comply with CE regulation. These regulations are designed to provide reasonable protection against harmful inter-ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with this manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular situation.
Product Description The IR-EGGS2 Wireless Infrared Remote Control Extender enables you to extend the range of your present Infrared Remote Control so that you can operate VCRs, stereos, Cable Converter, Satellite receivers, etc. Virtually any where within your home. Unlike ordinary remote controls which are only effective in close range." line of sight" use, The IR-EGGS2 use the radio frequency which can operate through walls, doors, around corners, etc.
APPLICATION DIAGRAM 1. Stereo system with remote control: IR-EGGS2 Receiver IR Signal RF Signal Wire to Extension Speaker Probe Stereo Wall IR Remote Control IR-EGGS2 Transmitter 2.
Installation & Operation Guide Receiver Picture 2 Picture 1 Working with extender probe Antenna Power Adaptor Keep Vertical (Using IR ) Make sure the IR probe is sticked toward IR sensor receiving Window with proper position (about within 1M and working angles 15o) Picture 3 Picture 4 Working without extender probe Working without extender probe Side View 15o DVD o o 15o 15 15 0.4 6.6M 7M Not less than 0.
Transmitter Picture 6 Picture 5 Working Angle not more than 15o Antenna Power Adaptor Keep Vertical o 15o 15 Remote Control Picture 7 Antenna 15o 15o 0.3 M 5.7M 6M Distance Not less than 0.
Care and Maintenance Keep the IR-EGGS2 Remote Extender dry. If it gets wet, wipe it dry immediately. Use and store the IR-EGGS2 only in normal temperature environments. Extreme temperature can shorten the life of electronic devices Handle the IR-EGGS2 gently and carefully. Dropping it can damage the circuit board and can cause it to work improperly. Keep the IR-EGGS2 away from dust and dirt, which can cause premature wear of parts. Wipe the IR-EGGS2 with a damp cloth occasionally to keep it looking new.
