User Guide

Windows – Property Sheets

3-20 Pi5501

NOTES

If “Staple” is set, printed pages are fed out into the Elevator Tray.

The stapling position is either the top left corner or the top right corner

depending upon the direction of the paper and the printing direction.

If the capacity of Mailbin Finisher, Single-staple Finisher, Multi-staple

Finisher or Folding Finisher is exceeded, the stapling operation may

be canceled. Refer to the Operator’s Manual of the machine.

If you print a document consisting of pages of different sizes in the

same printing job, stapling may be canceled.

Take care when printing a document consisting of pages facing

different directions, since the stapling position will be determined by

the direction of the first page.

You cannot set certain sizes or kinds of paper. For details, refer to the

Operator’s Manual of the machine.

Only Center Staple can be set with Booklet.

TIP

You can check the stapling positions using the icons in the dialog box.

2. Punch <when Mailbin Finisher, Multi-staple Finisher or Folding

Finisher is installed>

This function allows you to punch holes in the printed document.

Off:

The document is not punched.

Short Edge:

The document is punched along the short edge.

Long Edge:

The document is punched along the long edge

Punch Holes <Inch area only>:

Set the number of holes to be punched.