User Guide

6
Press ENTER . The LCD shows:
Note: If you have set 0000 for the I . D . code of the scan box, this LCD does
not appear. Skip to step 8.
7
Use the numeric keypad to enter the scan box’s four-digit I . D . code.
Then, press ENTER .
Note: If you’ve entered an incorrect
I . D . code, your machine rejects the
attempt and returns to standby mode.
8
Your machine will start scanning the document into the scan box.
If you are using the ADF, proceed to step 9.
If you are using the platen glass, skip to step 10.
9
If you have more documents to scan, press NEXT DOC during scan-
ning. Then proceed to step 10.
Otherwise, the machine will return to the standby mode after it has
finished scanning.
10
When the scanning is done, the LCD will show:
If you want to scan more pages, proceed to step 11.
Otherwise, press ENTER to finish scanning, and the machine will return
to the standby mode.
11
Place the next page.
If you want to change the scanner settings, press any of the cursor keys.
The LCD will show:
Change the scanner settings as you want, and then press ENTER .
(see steps 3 and 4)
Press NEXT DOC to start scanning.
To scan more pages, repeat steps 10–11. (If you’ve used the ADF, repeat
steps 9–11.)
Otherwise, press ENTER to finish scanning, and the machine will return
to the standby mode.
03:Store Doc 300dpi
A4 100%
Start Scan
→→
NextDoc
End Scan
→→
Enter
03:Store Document
Enter I.D. Code:****
2.12