User Guide

Set TCP/IP
When using the TCP/IP protocol, enter the IP Address, Subnet mask and
default Getaway.
Note:To access this function, the optional NIC (Network Interface Card)
must be installed. Contact your network administrator if you have
questions about these settings.
To enter your network settings:
1
Press Program key, B,4,0,1.
2
Press ENTER. The LCD will show:
3
Enter the IP Address for your printer using the numeric keypad,
then press ENTER to save the setting.
For example, your printer’s IP Address is 200.1.37.47, you should
press 2 0 0 0 0 1 0 3 7 0 4 7.
4
Press ENTER. The LCD will show:
5
Enter Subnet Mask address.
6
Press ENTER. The
LCD will show:
7
Enter default Gateway.
8
Press ENTER to save the setting. The machine will return to
standby mode.
9
To put the TCP/IP setting into effect, turn the machine off and then
on again.
Set Default Gateway
000.000.000.000
Set Subnet Mask
000.000.000.000
Set IP Address
000.000.000.000
01 TCP/IP

/

/Enter
1.24