User Guide

★ Indicator Ⓑ will not be on steady but will be
blinking, indicating the correct shutter speed for
the focus and film sensitivity. However, pictures
can be taken in manual photography at the
focus value and shutter speed Ⓐ set.
★ If you want to take pictures with the settings on
the correct value Ⓑ, turn the focus ring or
shutter dial to make both indications the same.
When the light state is at Ⓒ, you can take
pictures at the correct exposure.
Press the Shutter Release Button all the way
down to take the picture. The film will advance
on frame.
★ If the set shutter speed and correct value are
slower than one-half second, the LED indicator
inside the finder will be on “4” and blinking
slowly.
★ If the “4” or “4000” is blinking rapidly, this is a
warning that the shutter speed is outside the
linked range. If you want to set it to the correct
value, change the focus value.
★ In manual exposure, you can shift consciously
the indicator blinking on and off or steady on to
make the exposure either under or over to take
the kind of picture desired.