User guide

80 | Configuring connectors
Connector-specific configuration information
This section provides information about configuring each connector. For information about
configuring general properties, see “About configuring general Properties settings” on page 63.
For information about configuring connector services, see “About configuring connector Services”
on page 75.
Copy
Copy enables users to perform a variety of copying functions using an eCopy ShareScan OP client
embedded on a scanning device. When you activate Copy on a device running an embedded client,
the user does not need to quit the application to make copies.
To configure a Copy profile:
1
In the console tree, select Copy > Properties.
2 On the Display tab, specify the Image and Label settings (see “Configuring the Display
settings” on page 63).
3 Click Save, select or specify the profile name, then click Save.
4 In the console tree, select Copy > Services.
Tracing is the only service available for this connector.
5 On the Tracing tab, specify the Tracing settings (see “Configuring Tracing settings” on
page 80).
6 Click Save, select the profile name, then click Save.
Note: You can create Copy profiles on any ShareScan OP Services Manager, and publish them to any
Services Manager that supports the embedded client. However, you cannot run Copy on an
eCopy ScanStation.
Note: Copy is available for some, but not all, embedded clients. If you try to activate a Copy profile
on an unsupported device, the system will display an error message.