User guide

62 | Configuring connectors
Activating connector profiles
To make connector profiles available at a device, you activate the connectors and then select the
connector profiles. You can enable up to nine connector profiles on each device.
To activate connectors profiles:
1
In the console tree, select Devices > <device_name > Properties.
2 On the Selection tab, select the Activate Connector check box for your connector.
The
Select Connector Profiles window opens.
3 From the Select Profiles column, select the connector profile that you want to activate and
click
Save.
You can only select configured profiles; these appear in black. Unconfigured profiles appear in
red.
4 On the Selection tab, click Arrange.
The
Arrange Profiles window opens.
5 Use Move Up and Move Down to arrange the connectors in the list in the order in which you
want the client to display the connector buttons, then click
Save.
6 On the Selection tab, click Save.
The profile is now activated for the device.
Note: You can publish connector profiles individually or in groups to one or more
eCopy-enabled devices (see “Publishing connector profiles” on page 150).