User guide

eCopy ShareScan OP Installation and Setup Guide | 37
The scanner settings that you specified on the device’s Scanner Settings tab are displayed in
the lower left corner of the screen, unless you enabled use of the TWAIN driver’s interface.
If you are using the client with Send to eCopy, the settings in the lower left corner of the screen
will not appear.
6 Select the connector button.
If prompted, select your TWAIN-enabled device.
If the TWAIN driver’s user interface window opens, specify the settings that you want to use,
then press the “Scan” button.
For information about using the connectors, see “Connector-specific configuration
information” on page 80).
7 To quit the client application, use either of the following methods:
> If you are using the hard keyboard, press
ESC or Alt+F4. When the Exit window opens, enter
the exit password, then select
Yes.
> If you are using the on-screen (soft) keyboard, press
About, press (Exit) on the Version
tab, enter the exit password, then press
Yes.