User Guide

73
Measurement
Preparation
5.
Press
MENU
key.
Menu 1/4 screen appears on LCD screen.
6.
Press either
or key to select
<CH SETTING> and then
ENTER
key.
< CH SETTING> screen appears.
7.
Press either
or key to select
[CH RESET] and then
ENTER
key.
< RESET > screen appears.
8.
Press
ENTER
key.
After “ PLEASE WAIT...” appears and it
is reset, <RESET> screen appears.
When “ PLEASE WAIT...” appears, do not
switch OFF. Doing so may break stored data.
9.
As in procedure
3
, you can switch
calibration channel to continue to
reset other calibration channel.
Note that original calibration channel
appears when you return to measurement
screen in procedure
10.
10.
Press
ESC
key three times to
return to measurement screen.
CH RESET
< MENU > 1/4
CH SETTING
MEAS MODE SINGLE
SYNC MODE
DELETE
BREAK : [ESC]
[ ] [ 2° ]
< CH SETTING >
CH01: < DEFAULT >
USER CAL
CH ID NAME
CH COPY
CH RESET
BREAK:[ESC]
[ ] [ 2° ]
<RESET>
CH
01
:
Lv 100.77
x 0.3945
y 0.4000
OK TO RESET
THIS CH ?
OK : [ENTER]
CANCEL : [ESC]
[ ] [ 2° ]
CH01: < DEFAULT >
Lv ------
cd/m
2
x ------
y ------
< MODE > SINGLE
[ ] [ 2° ]
< ANGL > 1 ° VIEW
< SPD > AUTO
< SYNC > 60.00Hz
< LENS > STANDARD
< MEM > AUTO NUM
< MEMORY DATA >
M000 :(NO DATA)
Lv ------
x ------
y ------
< CH SETTING >
CH01: < DEFAULT >
USER CAL
CH ID NAME
CH COPY
CH RESET
BREAK:[ESC]
[ ] [ 2° ]