User Guide

Copy Paper
4
CF1501/CF2001 4-7
❍ For “A3Wide” paper, adjust the
trailing-edge guides as shown in
the illustration.
4 Load the paper into the drawer so
that the front side of the paper (the
side facing up when the package
was unwrapped) faces up.
?
Has the paper been loaded
correctly?
If the paper is not loaded
correctly, a paper misfeed may
occur.
➜ Make sure that the paper is not curled when it is loaded.
➜ Do not load so much paper that the top of the stack is higher than
the Ä mark.
➜ Do not load more than 20 sheets of thick paper 1, overhead
projector transparencies, or postcards.
➜ Do not load thick paper 2 into the 1st drawer. If you wish to make
copies onto thick paper 2, feed it through the manual bypass tray.
➜ When loading additional paper, remove any paper remaining in the
drawer, place it on the new paper, and then align the paper in the
stack well before loading it into the drawer.
➜ We recommend replenishing the paper only after all of the paper
in the drawer has been used.
CF2001.book Page 7 Friday, January 12, 2001 10:22 AM