User Guide

9
Administrator Mode Operations
9-24 CF1501/CF2001
To set the “Stabilizer” parameter
If the image is incorrect, even after the gradation levels have been
adjusted, set the “Stabilizer” parameter. The default setting is “Stabilizer
Mode”. The Stabilizer mode performs an image stabilization of the
previous data (background) to its original state.
1 In the Expert User’s Mode screen,
touch [Stabilizer].
The Stabilizer screen appears.
2 Select the desired mode, and then
press the [Start] key to adjust the
stabilizer automatically.
After the stabilizer is correctly
adjusted, the Expert User’s Mode
screen appears.
❍ First select “Stabilizer Mode”. If
the image is not corrected, select
“Reset And Stabilizer Mode”.
3 In the Expert User’s Mode screen, touch [Exit].
4 In the Administrator Mode screen, touch [Exit].
5 In the Utility screen, touch [Exit].
6 Copy a document, and then compare the copy to the original
document. Check that the copy is correct.
CF2001.book Page 24 Friday, January 12, 2001 10:22 AM