User Guide

7
Advanced Operations
7-6 CF1501/CF2001
7 On the left side of the screen, select
the pattern of the area that you wish
to be erased.
❍ To erase an area all along the
outer edge of the book, touch
(frame erase).
❍ To erase an area just along the
center binding of the book,
touch (center erase).
❍ To erase an area both along the
outer edge and along the center binding of the book, touch
(frame and center erase).
8 Touch and to specify the width that is to be erased.
❍ The width of the frame that is erased can be set between 1 and 30
mm (in units of 1 mm).
The default setting is “15”.
❍ The specified width of the area
to be erased is the width before
copying. Therefore, be careful
when selecting this setting while
making enlarged or reduced
copies.
Example) When using an erase
setting while copying an A3-size
document with a zoom ratio of “×
0.500”
9 Normally, the document size is
automatically detected. However,
when copying a document of a non-
standard size, touch [Original Size].
?
Is it unnecessary to specify the
size of the document?
➜ If the size of the document is not
to be specified, skip to step 12.
10In the Original Size screen, touch [X] and [Y], and use the keypad to
specify the desired size, and then touch [Enter].
The Book Erase screen reappears.
A3 A5T
× 0.5
20 mm 10 mm
CF2001.book Page 6 Friday, January 12, 2001 10:22 AM