User manual
Table Of Contents
- magicolor 1650EN
- Contents
- Ch.1 Introduction
- Ch.2 Using the Printer Driver
- Ch.3 Using the Status Monitor (Windows Only)
- Ch.4 Printer Control Panel and Configuration Menu
- Ch.5 Media Handling
- Ch.6 Replacing Consumables
- Ch.7 Maintaining the Printer
- Ch.8 Troubleshooting
- Ch.9 Installing Accessories
- Appendix
Configuration Menu Overview 4-17
INTERFACE MENU
With this menu, interface settings can be specified.
The printer must be rebooted after any setting in the ETHERNET menu (for
example, the TCP/IP address) is changed.
Therefore, the following message appears when the configuration menu is
exited (the + key is repeatedly pressed) after a setting has been changed.
Select YES, and then press the Menu Select key to reboot the printer.
Otherwise, turn off the printer, and then turn the printer on again after a few
seconds.
ETHERNET
*
INTERFACE MENU
TCP/IP ENABLE
IPV4 DHCP/BOOTP
IPV4 ADDRESS
DEFAULT ROUTER
SUBNET MASK
ENABLE AUTO IP
ENABLEIPV6
IDENTIFIERENABLE HTTPIP SERVICES