User Guide

1.3 Names of Control Panel Parts and Their Functions
1
Konica 8020/8031 1-13
Before Making Copies Chapter 1
* Job: Any set of consecutive operations, such as those for making copies, scans or computer printouts
9 [POWER SAVER] key • Press to enter and recover from Low Power mode and Shut
off mode.
10 [INTERRUPT] key • Press to enter Interrupt mode.
• When the [INTERRUPT] key is pressed, the key indicator
lights up in green to indicate that the machine is in Interrupt
mode. In addition, the message “Now in the Interrupt mode”
appears on the touch panel.
• To cancel Interrupt mode, press the [INTERRUPT] key
again.
11 [STOP] key • Press to stop a copy operation.
• Scanning of a document is stopped.
12 [START] key • Press to start a job.
• If this key is pressed during a continuous copy operation,
scanning for the job begins. (Queued copy) See p. 6-2.
• Press to continue an interrupted copy job.
• If this key is pressed while the copier is warming up, scanning
for the job begins. (Queued copy) See p. 1-16.
• The key indicator lights up in green to indicate that jobs can
be queued. The key indicator lights up in orange to indicate
that no jobs can be queued.
13 [C] (CLEAR QTY.) key • Press to reset the number of copies to “1”.
• Press to erase a setting, such as the zoom ratio or size,
selected using the keypad.
• The scanned image is erased.
14 Control panel release lever • Use when adjusting the angle of the control panel.
• Pull the release lever, and then push down on the control
panel to adjust its angle.
15 [ENLARGE DISPLAY] key • Will be used to enlarge the display. (Currently not available)
16 Touch panel contrast-
adjusting dial
• Use to adjust the contrast of the touch panel.
No. Part Name Description