User Guide

3
Administrator Mode
3-14 PageScope Light
✎
Tip
For details on setting the soft switches, refer to the Scanner Mode
User Manual.
Changing the settings for a registered account
In the Account List, click the account whose settings you wish to change.
The Account Registration page appears. Change the settings, and then
click the [Apply] button.
Network Settings: <Available only if the network scan kit or internet
fax & network scan kit is installed>
These settings are specified to prevent
anonymous e-mail from being sent. To identify
which account sent e-mail messages, specify a
“From” E-mail Address. (These parameters
appear only when bit 5 of software switch mode
366 is set to 1.) To receive authentication from
the POP3 server before the e-mail is sent to the
SMTP server, specify a POP3 User Name and
POP3 Password. (These parameters appear
only when bit 5 of software switch mode 366 is
set to 1 and bit 6 of mode 350 is set to 1.)
“From” E-mail
Address:
Type in the e-mail address for the account. (64
alphanumeric characters or less)
POP3 User Name: Type in the POP3 user name for the account. (64
alphanumeric characters or less)
POP3 Password: Type in the POP3 password for the account. (32
alphanumeric characters or less)
Retype POP3
Password:
Retype the POP3 password for the account.
[Cancel] button: Click this button to cancel the registration of the
account and return to the Account List page.
[Apply] button: Click this button to register the account with the
entered information.
[Clear] button: Click this button to clear the entered setting.